Windows dial up script

Wednesday, September 9, PM. Hi Julien, Thank you for your question. We could refer to the following steps to check if the issue persist: 1. Use the different accounts local administrator 2. Turn off Windows firewall 3. Best Regard, Jim Please remember to mark the replies as answers if they help, and unmark the answers if they provide no help. Monday, August 31, AM. Hi, Thanks for your answer! I have tried your solution but it's not worked. My connection is always blocked at authentication. I precise that i use the ras client.

Type the telephone number and destination name e. Dial-Up , on the Type the telephone number to connect to page, click Next button to continue. Type your user name and password, and make sure the Remember this password check box has been selected, on the Type your user name and password page, click Create button to continue.

Note: you must use the destination name which typed in step3, for example, Dial-Up. On the Options tag of the Dial-up Properties, Clear the following selection: a. Prompt for name and password, certificate, etc.

Include Windows logon domain. Prompt for phone number. How to establish a dial-up connection by rasphone. Click on Dial-up Connection , then choose Rename this connection :. When you see the dialog below, click on Configure :. Under the Options tab , select Display progress while connecting and set Idle time before hanging up to never :. Clicking on the Security tab initially gives me an error, but click OK and continue:.

Then, click on Internet Protocol Version 4 and click on Properties :. Select Use the following IP address and type in Be sure to unplug the USB cable of your mbed board. Wait patiently until all drivers have loaded. Then replug your mbed board. We already performed this in step Click Configure and ensure the speed is set to and all three options are unchecked.

If you did not perform the windows restart , you may not be able to make this change permanent - the values will change back:. It's crucial to now go back to step 27 and carefully re-check all the network adapter settings against the screen dump - especially step Windows sometimes inexplicably changes these values!!!

Also, if you are unable to permanently change a setting, or settins inexplicably revert back to other values, it's time to restart Windows, which properly sequences all the settings and driver changes.

Ensure that you have compiled the PPP-Blinky source code for your mbed hardware platform, use compile-all , have downloaded the binary, and have pressed the reset button on your board to ensure the latest downloaded binary is running.

Press reset on your mbed board now , because once PPP blinky sees a tilde character, it assumes that it is "online" and will not respond to dial-up commands from the PC until it has received an LCP-end packet to end the connection. So, to re-iterate, press reset on your mbed board now. Alternatively, Alt-B, which sends a line break in Tera Term, also works to reset many mbed-enabled boards. This is the dial-up response string expected by Windows to signal a successful direct cable connection between two computers.

Change the file extension on each file to. In the System File Checker tool, click the Extract one file from installation disk option. In the Specify the system file you would like to restore box, type tapi In the Restore from box, click the drive where you installed Windows.

Repeat steps 6 through 9 for each of the files below. NOTE: A damaged modem driver or incorrect modem driver can also create this problem. If the problem continues, try removing and reinstalling the modem from Device Manager. Make sure you have the current modem drivers available to reinstall. General More Need more help? Expand your skills.

Get new features first.